NVH 是下列哪一項之英文縮寫名稱
- ① Nocking, vibration, and harshness
- ② Noise, vibration, and heat
- ③ Noise, vibration, and harshness
- ④ Noise, volume, and harshness
顯示正解 收合正解
正確答案:③
Catalytic converter 是下列哪一項之英文名稱
- ① 扭力變換器
- ② 電晶體
- ③ 自動變速箱
- ④ 觸媒轉換器
顯示正解 收合正解
正確答案:④
N VH 是下列哪些英文縮寫組合
- ① Noise
- ② Vibration
- ③ Heat
- ④ Harshness
顯示正解 收合正解
正確答案:①②④ (複選,需全部選對)
W hen tighten a series bolts or nuts
- ① begin with the center bolt
- ② begin with large diameter bolts
- ③ tighten bolt in crisscross pattern
- ④ tighten in one step
顯示正解 收合正解
正確答案:①②③ (複選,需全部選對)
下 列英文縮寫何者正確?
- ① DTC:Diagnostic Trouble Code
- ② GPS:Global Planet System
- ③ EGR:Exhaust Gas Recirculation
- ④ ECT:Engine Coolant Temperature
顯示正解 收合正解
正確答案:①③④ (複選,需全部選對)
從 下表的資料可得知需要的機油容量,下列何者正確?
- ① 引擎大修 4.2L
- ② 更換機油不含機油芯 3.6L
- ③ 更換機油不含機油芯 3.4L
- ④ 更換機油含機油芯 3.6L
顯示正解 收合正解
正確答案:①③④ (複選,需全部選對)
起動時引擎無法搖轉(cranking),可以進行哪些檢查?
- ① battery test
- ② starter test
- ③ check fuel pressure and fuel pump circuit
- ④ check ECT sensor
顯示正解 收合正解
正確答案:①② (複選,需全部選對)
有 關 shear bolt 的敘述,下列何者錯誤?
- ① tighten the shear bolts A until the hex heads B twist off
- ② tighten the hex heads B until the shear bolts A twist off
- ③ loosen the shear bolts A until the hex heads B twist off
- ④ loosen the hex heads B until the shear bolts A twist off
顯示正解 收合正解
正確答案:②③④ (複選,需全部選對)
汽 油噴射引擎當進行燃油壓力測試時,包括下列哪些步驟?
- ① relieve the fuel pressure
- ② disconnect the quick-connect fitting and attach the fuel pressure gauge
- ③ open the fuel tank filler cap
- ④ read the fuel pressure gauge
顯示正解 收合正解
正確答案:①②④ (複選,需全部選對)
如 圖所示,下列敘述的步驟何者正確?
- ① install the brake pad
- ② inspect the brake disc surface for damage or cracks
- ③ set up the dial gauge
- ④ measure the runout at 10mm from the inner edge of the brake disc
顯示正解 收合正解
正確答案:②③④ (複選,需全部選對)
檢 查汽車的車輪定位包括下列哪些項目?
- ① caster
- ② camber
- ③ toe-in
- ④ tire wheel runout
顯示正解 收合正解
正確答案:①②③ (複選,需全部選對)
F or brake booster leakage test, we should do the below procedure
- ① install the vacuum gauge between booster and check valve
- ② start the engine and keep the engine running at all time
- ③ read the vacuum gauge
- ④ make sure vacuum reading should not decrease within 30 sec
顯示正解 收合正解
正確答案:①③④ (複選,需全部選對)